Resincoat Block Paving Sealer

Resincoat acrylic resin block paving sealer is a premium formulation designed to protect & seal your driveway, preventing moss and weed growth. Formulated by our chemists, the sealer boasts an eco-friendly design that is solvent free, making it animal & wildlife friendly. The application of this sealer can prevent and greatly reduce dirt build up and is resistant to oil spills and water damage prolonging the lifespan of your driveway. Sealing your driveway will help with the overall maintenance of your block paving, leading to significant long-term savings as well as reducing interim maintenance.

The formula works by sealing the pores to prevent dirt and soaks into the kiln dried sand, binding the sand, creating a barrier to prevent the growth of weeds and moss. It also protects the paver face from oil and water infiltration offering a professional looking finish that will remain looking good for years to come. For best results we recommend joints to be repointed with a kiln dried sand before use of this product.

Resincoat block paving sealer offers excellent coverage. We always advise 2 coats for a durable, professional finish. The sealer boasts a high synthetic resin content with low VOC & low odour. Please see below for coverage rate:

Approximately 5m2 per litre 

Coverage rates will vary depending on the condition of the driveway and the amount applied per coat. 

Preparation

Remove loose or flaking material. Make sure the surface is clean (no dirt or grease). Ensure the surface is 100% dry and free from any contamination before application. Do not apply if there is a chance of rain.

Cleaning & Repointing

You will want to ensure your driveway is thoroughly cleaned. Use a stiff broom to to remove any large debris. If desired you may then wish to use a jet wash or pressure washer to rinse the surface clean of all loose dirt, sand, and grit. Once complete, leave the surface to thoroughly dry.

Once the surface is dry you can begin to repoint your block paving applying a kiln dried sand. Use this product directly from the bag scattering it throughout your driveway then use a wide, soft brush to gently brush it in to your paving joints.

Application 

This product can be brush, roller or spray applied.

If using a spray, follow instructions as per the manual provided. This product does not need diluting. 

If using a brush or roller, distribute a little of the product over your surface and use your brush or roller to evenly spread the product, ensuring you apply a thin coat. Leave to dry and then apply a second coat. To achieve a more enhanced finish you may wish to apply a third coat. We recommend roller applying the coating thinly and leaving the paint to dry for at least 24 hours before driving cars on the freshly coated driveway.

Do not drive on the surface for 24 hours after last coat.