Resincoat Epoxy Crack Repair Filler

Resincoat Epoxy Crack Repair is ideal for cracks up to 2cm deep. Repairing small concrete cracks can be hugely cost effective in the long run as over time cracks will expand and cause the concrete around them to weaken and possibly become dangerous. This product is suitable for repairing cracks in just about any concrete including; floors, steps, paving and patios. The formula will cure harder than the concrete around it and provide a cost effective waterproof solution that stands the test of time. Ideal for DIY customers the crack filler an be easily poured ensuring a quick and easy repair allowing you to achieve a professional finish with a curing time of under 24 hours. 

All our resin products are proudly manufactured in the UK for guaranteed quality and performance.

1kg - Covers maximum 6 metres @ 12 mm wide x 12mm deep

Preparation:

Before use of this product we recommend the area should be vacuumed to remove any loose material or existing debris which could cause the epoxy formula to set unevenly. If the crack is large enough a wire brush should be used to clean out the crack. For a clean application angle grind the crack to achieve a better look, if you suspect the crack runs the complete depth of the epoxy add some kiln dried silica sand to the bottom of the crack to create a bund.

Application:

1. Thoroughly mix parts A & B of your epoxy crack repair using a drill and paddle for a minimum of 90 seconds

2. Pour the formula in to the crack distributing it evenly as you go until the crack is filled

3. Once filled allow 12 - 24 hours for the epoxy to fully cure

Please note the formula is also suitable for use with a pressure injection though this may differ on a case by case basis. Should you require further information please call our technical team on 0113 827 2387.

Please note: The pot life of this product is 20 minutes. This is not to be confused with working time. Resincoat crack repair has a working time of approximately 30-40 minutes dependant on ambient temperature.

Pot life = Time to harden in pot following addition of hardener
Working Time = Time to apply product before becoming unworkable