Resincoat Liquid Rubber Waterproof Coating

This liquid rubber waterproof repair product can successfully seal gaps between roofing sheets or small holes around skylights, chimneys and other roof accessories. This highly advanced system provides a fully bonded repair with excellent insulating properties providing a completely seamless waterproof finish. Ideal for emergency flat roof repairs or general maintenance this liquid rubber is great for repairing leaks or cracks on any flat roof. A single layer application can successfully repair your flat roof boasting a highly durable long lasting finish. 

Its liquid consistency makes it extremely easy to work with ideal for both DIY & industrial users. The product is extremely flexible and can be used on both horizontal and vertical surfaces.  The coating will reach every crack no matter how large or small and offers a black appearance when dry. The movement of the roof through expansion, contraction and vibration will not affect the integrity of this product. The ability to stretch to 1000% of its original mass and its cold liquid application by brush, roller or Spray make this item the leader in its field. Resincoat liquid rubber is UV stable therefore can be used outdoors without the worry of fading or discolouring.

This product is ready for use on Flat Roofs, Weathered Asphalt and Bituminous Surfaces, Felt Concrete, Brickwork, Weathered Plys, OSB/Plywood, Wooden Substrates and EPDM.

Not for use on tanking, fishponds, lead, plastisol coated substrates or internal use.

 Single coat: minimum of 1Kg/m2 / 1 litre/m2

The curing time for this product is up to 8 hours or overnight depending on temperature and conditions. Full cure up to 7 days. We advise you check the weather conditions prior to applying this product and avoid application in extreme weather conditions. Always apply this product on a dry surface. Application temperature should be between 5°C-25°C.

Preparation –

Before application of this product we advise you fully clean the roof surface to make sure it is free from dust, dirt, oils, surface flaking, poorly bonded or glossy paint, sealers, varnishes, salts or any other contaminants. Any damaged surfaces must be fully repaired prior to application. Please note your surface must be completely dry before application of this product, it cannot be applied on wet or damp surfaces. 

Highly porous/friable surfaces may require the use of a primer before coating with this product. We advise to inspect and carry out an adhesion test on any existing porous surface or substrate prior to application of the coating.

Surface Preparation with Geotextile Tape –

All joints, seams, cracks, vents etc must be bridged with Geo fabric as per the instructions. All joints, e.g. of torch-on membrane, sheet metal, vertical and horizontal transitions, must be additionally reinforced with Geotextile at a 10-15 cm width.

Recommendations:
*Apply Geotextile tape to all areas which can be ponded.
*Geotextile tape must be used on all upstands, curves, skylight bases and rainwater outlets.
*Geotextile tape must be used on all gutter expansion joints.
*Geotextile tape to be used on all repaired areas

Application of Geotextile Tape:

Geotextile tape is embedded into the wet liquid rubber coating avoiding creasing. Adjacent lengths of the reinforcement must overlap by 75mm. Finish with one coat of liquid rubber waterproof coating to seal the tape.

Application Instructions –

•    Stir the product well before use 
•    Begin applying the coating to your surface using either a brush or roller just like you would apply a layer of paint 
•    Apply a single layer of this product
•    Leave to fully cure