Resincoat Concrete Floor Paint

At Resincoat we are always trying to improve our range and develop new products that are cost effective, easy to use and look great. Our concrete floor paint achieves just that. The one-pack formula makes the paint extremely easy to use, just give it a thorough stir and then you're ready to roll it onto your floor. This floor paint has been tested and compared to the competition and has proven to be tougher, longer-lasting and just as good looking as coatings twice its price point.

Resincoat Concrete Floor Paint is, as the name suggests, a great choice for concrete floors. The formula is an excellent choice for home use in basements as a dust-proofing and sealing paint, in workshops, sheds and garages as a decorative coating that has a tough finish.

For the toughest professional finish consider: Resincoat HB Epoxy Garage Floor Paint

For a chemical resistant finish consider: Resincoat Chemical Resistant UVR Floor Paint

For an high build anti-slip option try: Resincoat Anti-Slip Floor Paint

​

*Please note there could be a colour variation between batches please bare this in mind if you are placing another order. If you have any questions regarding this please call our team on 0113 827 2387.

Preparation:

Important pre-requisites:

• Apply only in dry conditions - ideally the coating should avoid rainfall for 2 days where possible. 7 days should be allowed before jet washing.
• 2 - 3 coats is recommended.
• Surface must be washed and then allowed to fully dry before application.
• Suitable etching formula should be used such as Resincoat Etch & Clean.
  
• Due to the amount of variation in patio substrates, we highly recommend applying to a small test area first to ensure a perfect bond and desired finish.

Application:

We recommend the weather be dry & warm whilst applying this product but not overly humid.

1. Ensure you have used Etch & Clean

2. Stir the paint thoroughly before use. 

3. Begin applying the paint using a brush or roller. Please note the paint should be applied thinly. 

4. Once the first coat has been applied leave to dry. Your brush or roller can be cleaned in tepid water ready to be reused for subsequent coats.

5. Apply your second coat.

6. Leave to dry & apply a third coat if required.