Hygienic Kennel & Cattery Paint

Resincoat Hygienic Kennel & Cattery Paint is the premier choice for animal safe flooring in the UK. Our coating is easy to install and guarantees a professional finish with your surface ready for use again in just 24 hours. Most importantly, our formula is designed, tested and manufactured by Resincoat with the help of our partner kennels and catteries to ensure it meets the high standards required by our customers.

Two coats of Resincoat Hygienic Kennel & Cattery Paint can provide the equivalent of ten coats of conventional solvented or water based floor coatings. The coating is also resistant to spills meaning that when accidents happen, liquid will pool rather than sinking into your concrete. This makes cleaning up much easier and ensure the long life of the finish.

Coverage rates may vary dependent on your starting substrate but we're always on hand to provide installation advice! If you're not sure just give us a call and we'll be happy to assist.

1kg: 3-4m² approx

2.5kg: 8-10m² approx

5kg: 17-20m² approx

10kg: 35-40m² approx

Preparation:

The key to a perfect finish is surface preparation. Before applying Resincoat Hygienic Kennel & Cattery Floor Paint we recommend all existing paint finishes are removed and the surface is abraded or primed where required. Fully vacuum the area to ensure it is free from dust and laitance. Mechnical preparation such as shot blasting or grinding is the preferred method but if that is not possible or not practical we recommend use of Resincoat Etch and Clean.  Please note for 2 coats you will require 2 epoxy rollers.

Please see below for the best primer for your floor:
• For new concrete floors prime with Resincoat Damp Tolerant Primer
• For dusty or old floors prime with Resincoat Deep Penetrating Primer
• For greasy floors with oil residue clean thoroughly scraping off any dust or dirt and prime with Resincoat Oil Tolerant Primer

Application:

1. Pour 100% content of part B in to part A

2. Mix resin components together with a drill and paddle for 1 minute

3. Pour content in to a paint scuttle

4. Immediately begin applying your paint with an epoxy roller frame and sleeve

5. Use a brush around the edges for a smooth finish (a second pair of hands comes in useful)

6. Once coat one has been applied leave 12-24 hours then apply second coat

*Ensure pets are kept off the surface for at least 3 days after painting.

PLEASE NOTE: The pot life of this product is 20 minutes. This means the paint will start to chemically cure after this time. Ensure you remove the paint from the tin in this window. The paint will then be workable on your floor for 40 minutes. 

• This product is NOT UV stable therefore will discolour when exposed to sunlight. Please coat with a coloured UVR coating such as Resincoat Chemical Resistant UVR Floor Coating for a UV stable finish.
• This product can NOT be split. Taking smaller quantities from each tin, even if measured correctly, may cause issues with activating. The resin formula is chemically manufactured to work efficiently and effectively based on the exact amounts supplied in full tins for parts A & B
• This product is NOT self levelling
• If you require a clear epoxy coating visit our clear epoxy product here
• The key factors for product adhesion are:
  • Surface Laitance removal
  • Compressive Strength > 25N/mm2
  • Relative Humidity of <85% for 1 coat or <90% for 2 coats of Damp Tolerant Primer
  • Effective DPM underneath the main slab