Application Instructions:
To apply, ensure the starting surface is clean, dry and completely free of contamination. It is critical to prime the surface to seal it fully before you begin.
Due to the impact on the finished result, for a perfectly level finish we advise to prime twice. A general system would be two coats of a relevant and suitable primer for your substrate.
For example, if you are applying to new concrete, we recommend two coats of Damp Tolerant Primer. If the floor is oil contaminated, you should use one coat of Oil Tolerant Primer followed by a coat of Standard Epoxy Primer.
It is important to seal the concrete fully as the epoflow system is very epoxy rich and if applied to insufficiently sealed concrete, the concrete may absorb some of the resin which could potentially leave an uneven finished result.
Once your primer has fully cured, begin applying Epoflow Self Levelling Screed.
Mix all parts together and then pour onto the surface and smooth using a flat trowel. Once the desired result is achieved, allow the system to fully cure for up to 48 hours before trafficking.
See Technical Data Sheet for full product instructions.